Mail Archive Search: <+subject:/^(?:^\s*(re|sv|fwd|fw)[\[\]\d]*[:>-]+\s*)*Datsun\s+driveshaft\s+modifications\s*$/>

Results:

References: [ +subject:/^(?:^\s*(re|sv|fwd|fw)[\[\]\d]*[:>-]+\s*)*Datsun\s+driveshaft\s+modifications\s*$/: 7 ]

Total 7 documents matching your query.

1. Datsun driveshaft modifications (score: 1): Author: Unknown; Date: Sun, 29 May 2005 12:00:12 -0700; Here is a link to the pictures of what I had to do to the tunnel of my Bugeye to get the driveshaft to slide into the Datsun transmission. It was a last resort after several attempts to accomplish it; /html/spridgets/2005-05/msg01176.html (7,720 bytes)
2. Re: Datsun driveshaft modifications (score: 1): Author: Unknown; Date: Sun, 29 May 2005 12:06:51 -0700 reply-type=response; I don't understand. I've done this swap on three cars (2 1275's & 1 948) and never had a problem. I wonder what's different about your car.; /html/spridgets/2005-05/msg01177.html (8,362 bytes)
3. Re: Datsun driveshaft modifications (score: 1): Author: Unknown; Date: Sun, 29 May 2005 12:33:18 -0700; Those same sentiments were voiced by everyone including Paul A. Believe me when I say it was a bi** to try to install without the hole. Even after cutting the hole I still had to tap it in from the d; /html/spridgets/2005-05/msg01178.html (9,520 bytes)
4. Re: Datsun driveshaft modifications (score: 1): Author: Unknown; Date: Sun, 29 May 2005 12:53:12 -0700; Doesn't it have to be able to slide in and out easily as the suspension moves? What was binding? Was the oil seal too tight, or were the splines not meshing properly?; /html/spridgets/2005-05/msg01179.html (7,359 bytes)
5. Re: Datsun driveshaft modifications (score: 1): Author: Unknown; Date: Sun, 29 May 2005 14:17:30 -0700; It was only the fact that there was nothing supporting the u-joint while I was trying to push it in. Tapping on it just forced it to straighten out. Mike -- Mike MacLean 60 Sprite 56 BN2 http://home.; /html/spridgets/2005-05/msg01180.html (8,037 bytes)
6. Re: Datsun driveshaft modifications (score: 1): Author: Unknown; Date: Sun, 29 May 2005 14:32:22 -0700 reply-type=response; Are you saying that this was all because of a floppy u-joint? If so, there are lots of ways to get around that.; /html/spridgets/2005-05/msg01181.html (8,668 bytes)
7. Re: Datsun driveshaft modifications (score: 1): Author: Unknown; Date: Sun, 29 May 2005 15:36:31 -0700 reply-type=response; Was the edge of the u-joint hitting the top of the tunnel?; /html/spridgets/2005-05/msg01184.html (9,867 bytes)

Current List: 1 - 7
Page: [1]