Mail Archive Search: <+subject:/^(?:^\s*(re|sv|fwd|fw)[\[\]\d]*[:>-]+\s*)*Final\s+Front\s+Suspension\s+Q\'s\s*$/>

Results:

References: [ +subject:/^(?:^\s*(re|sv|fwd|fw)[\[\]\d]*[:>-]+\s*)*Final\s+Front\s+Suspension\s+Q\'s\s*$/: 6 ]

Total 6 documents matching your query.

1. Final Front Suspension Q's (score: 1): Author: Unknown; Date: Thu, 08 Jun 2000 23:40:28 -0400; Hi All!! Well, hopefully I'm nearing the end of the front suspension rebuild on the Sprite. However, I need a few tips... 1) How critical is it that the kingpin cotter pin be driven all the way thru?; /html/spridgets/2000-06/msg00388.html (7,757 bytes)
2. Re: Final Front Suspension Q's (score: 1): Author: Unknown; Date: Fri, 9 Jun 2000 00:06:52 EDT; Allignment can be done "to run" by using a long straight edge to span from back tire to front. Raise it up about 5" so it contacts both sidewalls of both tires. Move it from left to right until each; /html/spridgets/2000-06/msg00390.html (7,122 bytes)
3. Re: Final Front Suspension Q's (score: 1): Author: Unknown; Date: Fri, 09 Jun 2000 08:23:58 -0500; -- If you mean the cotter locating the kingpin to the lower trunion pin, it should be able to go in all the way... in fact, if all is right it pushes in quite easily. My experience has been that if i; /html/spridgets/2000-06/msg00400.html (8,656 bytes)
4. Re: Final Front Suspension Q's (score: 1): Author: Unknown; Date: Fri, 09 Jun 2000 10:29:22 -0700; You are talking about the wedge shaped pin right? Do you still have an old one? Compare the new to the old. It almost seems that I remember that I had the same problem and eventually determined that; /html/spridgets/2000-06/msg00415.html (7,660 bytes)
5. Re: Final Front Suspension Q's (score: 1): Author: Unknown; Date: Fri, 9 Jun 2000 11:02:20 -0700 (PDT); When I rebuilt my front suspension, I happen to have 2- new sets of pins to the king pins to the lower 'pivot screw/pin'. one set fit, and the other would only go about half way in. - Bryan; /html/spridgets/2000-06/msg00419.html (8,282 bytes)
6. Re: Final Front Suspension Q's (score: 1): Author: Unknown; Date: Sat, 10 Jun 2000 00:58:15 -0400; I compared my 2 sets of cotter pins and found one set to have a larger flat "edge", thereby having a slightly smaller diameter. When I did the second side kingpin to a-arm install, it went in pretty; /html/spridgets/2000-06/msg00445.html (8,029 bytes)

Current List: 1 - 6
Page: [1]