Mail Archive Search: <+subject:/^(?:^\s*(re|sv|fwd|fw)[\[\]\d]*[:>-]+\s*)*Rear\s+Hub\s+End\s+Play\s+and\s+the\s+Factory\s+Service\s+Manual\s*$/>

Results:

References: [ +subject:/^(?:^\s*(re|sv|fwd|fw)[\[\]\d]*[:>-]+\s*)*Rear\s+Hub\s+End\s+Play\s+and\s+the\s+Factory\s+Service\s+Manual\s*$/: 2 ]

Total 2 documents matching your query.

1. Rear Hub End Play and the Factory Service Manual (score: 1): Author: "J Garruba" <jgarruba@ematic.com>; Date: Tue, 27 Feb 2001 22:17:01 -0800; Dear Listers, In researching a job on my rear driveline, I came across an interesting procedure in the 72 Factory Service Manual. Apparently, it recommends tightening the large stub axle bolt in the; /html/6pack/2001-02/msg00211.html (7,016 bytes)
2. Re: Rear Hub End Play and the Factory Service Manual (score: 1): Author: Btp44@aol.com; Date: Wed, 28 Feb 2001 01:33:00 EST; Joe-Yes, you can remove excessive end play without disassembling and replacing the collapsible spacer. Just make sure that the end play is not reduced below the.002"-.004" spec. If this happens, then; /html/6pack/2001-02/msg00212.html (6,899 bytes)

Current List: 1 - 2
Page: [1]