- 1. Rear hub studs and nuts (score: 1)
- Author: "BJ8Healeys" <sbyers@ec.rr.com>
- Date: Thu, 5 Oct 2006 10:14:06 -0700
- Since the workshop manual does not specify a torque for the wire wheel rear hub splined adapter nuts, this information might be helpful: I just replaced the studs in the left rear wheel of my BJ8. I
- /html/healeys/2006-10/msg00115.html (7,368 bytes)
- 2. Re: Rear hub studs and nuts (score: 1)
- Author: "Ph.J.Aeckerlin" <j.aeckerlin@tiscali.nl>
- Date: Thu, 05 Oct 2006 20:40:32 +0200
- Come on, Steve! The Metric Crowd is very happy not having to work in inches, feet, yards and miles but in millimeters, centimeters, meters and kilometers , in Centigrade instead of Fahrenheit and in
- /html/healeys/2006-10/msg00118.html (7,981 bytes)
- 3. RE: Rear hub studs and nuts (score: 1)
- Author: "Michael Salter" <msalter@precisionsportscar.com>
- Date: Thu, 5 Oct 2006 14:41:42 -0400
- Hi Steve, Very much appreciate the information. As you know "loosening off "of these is often a problem on wire wheel cars so correct tightening torque is very important. However, the biggest problem
- /html/healeys/2006-10/msg00119.html (8,766 bytes)
- 4. Re: Rear hub studs and nuts (score: 1)
- Author: GLWilkieAlaska@aol.com
- Date: Fri, 6 Oct 2006 18:30:13 EDT
- Since the workshop manual does not specify a torque for the wire wheel rear hub splined adapter nuts, this information might be helpful: I just replaced the studs in the left rear wheel of my BJ8. I
- /html/healeys/2006-10/msg00138.html (7,516 bytes)
- 5. Re: Rear hub studs and nuts (score: 1)
- Author: "Alan Seigrist Blue 100" <healey.nut@gmail.com>
- Date: Sat, 7 Oct 2006 10:33:02 +0800
- By the way, on a four stud axle on early BN1s, you definitely don't want to be torquing these nuts at 70+...~35 is about right. Do it too tight and you'll make it easier to strip the studs from the h
- /html/healeys/2006-10/msg00140.html (8,121 bytes)
- 6. Rear hub studs and nuts (score: 1)
- Author: "Allyn Richardson" <allynrichardson@cox.net>
- Date: Sat, 7 Oct 2006 06:32:27 -0700
- Doesn't the standard torque table only address the max. elongation of the bolt given the core hardness / tensile strength of the fastener but doesn't take into account the material condition being f
- /html/healeys/2006-10/msg00142.html (7,135 bytes)
This search system is powered by
Namazu