- 1. Refitting a tenax stud (TR3) (score: 1)
- Author: Unknown
- Date: Wed, 28 Oct 1998 23:55:31 -0500 (EST)
- The left most tenax stud for the convertable top is long missing and the hole in the windshield frame that it came out of is much too oversized for a new one, at least any I've been able to find. Ha
- /html/triumphs/1998-10/msg01998.html (6,908 bytes)
- 2. Re: Refitting a tenax stud (TR3) (score: 1)
- Author: Unknown
- Date: Thu, 29 Oct 1998 06:34:40 -0800
- My windshield frame has already been drilled through for all of the tenax studs. Those that were installed look like a long countersunk screw with the tenax on the end. A nut goes over the outside en
- /html/triumphs/1998-10/msg02008.html (8,336 bytes)
- 3. Re: Refitting a tenax stud (TR3) (score: 1)
- Author: Unknown
- Date: Thu, 29 Oct 1998 17:12:15 EST
- << The left most tenax stud for the convertable top is long missing and the hole in the windshield frame that it came out of is much too oversized for a new one, at least any I've been able to find.
- /html/triumphs/1998-10/msg02036.html (7,629 bytes)
- 4. Re: Refitting a tenax stud (TR3) (score: 1)
- Author: Unknown
- Date: Thu, 29 Oct 1998 04:41:32 -0500
- This an uproven, off the wall idea. I wonder if a piece of small hobby tubing or pop rivet body could be used in a fashion similar to the way expansion anchors work in wallboard and concrete. It woul
- /html/triumphs/1998-10/msg02066.html (8,559 bytes)
- 5. Re: Refitting a tenax stud (TR3) (score: 1)
- Author: Unknown
- Date: Fri, 30 Oct 1998 08:32:05 -0800
- No idea if this would work - another off-the-wall-idea - but if I have a wood screw hole that's worn too large, I insert a toothpick or other small sliver of wood into the hole before inserting the s
- /html/triumphs/1998-10/msg02070.html (10,044 bytes)
- 6. RE: Refitting a tenax stud (TR3) (score: 1)
- Author: Unknown
- Date: Fri, 30 Oct 1998 13:13:18 -0000
- that'll work for a short time (the copper, not sure about the brass but thats pretty brittle stuff, so I gues that too, but it'll work loose in due course. the only real solution is to weld the hole
- /html/triumphs/1998-10/msg02071.html (8,083 bytes)
This search system is powered by
Namazu