- 1. Seeking advice on MGB steering rack install (score: 1)
- Author: "Marc" <smarc@abs.net>
- Date: Sun, 24 Mar 2002 01:56:08 -0500
- Greetings all - I was hoping I could elicit some advice regarding the reinstallation of a steering rack in my 1973 MGB. I'm finding this to be a very difficult task. I had removed the entire crossmem
- /html/mgs/2002-03/msg00937.html (8,078 bytes)
- 2. Re: Seeking advice on MGB steering rack install (score: 1)
- Author: <paul.hunt1@virgin.net>
- Date: Sun, 24 Mar 2002 15:50:00 -0000
- Shims were fitted by the factory to set the alignment of the rack, both the vertical and horizontal position of the column-end of the rack shaft. Stress on the column-shaft bearing is the issue, not
- /html/mgs/2002-03/msg00950.html (9,832 bytes)
- 3. RE: Seeking advice on MGB steering rack install (score: 1)
- Author: "Marc" <smarc@abs.net>
- Date: Sun, 24 Mar 2002 12:36:13 -0500
- My thanks to those who replied; I am prepared to attempt to solve this problem again. One thing I would like to know more about: Getting the shafts into and out of the U-joint is quite difficult. To
- /html/mgs/2002-03/msg00959.html (8,893 bytes)
- 4. Re: Seeking advice on MGB steering rack install (score: 1)
- Author: "Mike Winney" <mgb@cableone.net>
- Date: Sun, 24 Mar 2002 11:53:21 -0700
- --I am having a hard time getting the shaft back into the u-joint. Any tips on accomplishing this would be appreciated!-- I tapped the tapered end of an appropriate sized screwdriver into the u-joint
- /html/mgs/2002-03/msg00968.html (7,355 bytes)
This search system is powered by
Namazu