Mail Archive Search: <+subject:/^(?:^\s*(re|sv|fwd|fw)[\[\]\d]*[:>-]+\s*)*Stromberg\s+mixture\s+adjustment\s+follow\s+up\s+question\.\.\.\s*$/>

Results:

References: [ +subject:/^(?:^\s*(re|sv|fwd|fw)[\[\]\d]*[:>-]+\s*)*Stromberg\s+mixture\s+adjustment\s+follow\s+up\s+question\.\.\.\s*$/: 4 ]

Total 4 documents matching your query.

1. Stromberg mixture adjustment follow up question... (score: 1): Author: Josh Tarnow <jjtarnow@yahoo.com>; Date: Mon, 26 May 2003 09:24:18 -0700 (PDT); Listers, thanks for your help but I have one other question due to my concern over stripping the screw. Can the screw be turned so much that it stops (like a normal screw)? Or will the needle just co; /html/6pack/2003-05/msg00547.html (7,266 bytes)
2. Re: Stromberg mixture adjustment follow up question... (score: 1): Author: "Gary Fluke" <res0s0t7@verizon.net>; Date: Mon, 26 May 2003 10:39:35 -0700; My screws have a definite stopping point when richening and, of course, will unthread when going the other way. Gary '73 concern over stripping the screw. Can the screw be turned so much that it sto; /html/6pack/2003-05/msg00549.html (7,776 bytes)
3. RE: Stromberg mixture adjustment follow up question... (score: 1): Author: Mark Hooper <mhooper@pix-cinema.com>; Date: Mon, 26 May 2003 14:22:15 -0400; If you turn the screw clockwise fully, the needle will be drawn to the maximum rich position about 2 mm above the bottom of the carb piston. Since there is a blocking screw in the side of the piston; /html/6pack/2003-05/msg00551.html (8,547 bytes)
4. Re: Stromberg mixture adjustment follow up question... (score: 1): Author: "Gary Fluke" <res0s0t7@verizon.net>; Date: Mon, 26 May 2003 22:05:59 -0700; At this stage, if you haven't already removed the carb tops and pulled out the air control valves, you may wish to. It is not difficult to do. Then you would be able to examine the operation and con; /html/6pack/2003-05/msg00560.html (8,026 bytes)

Current List: 1 - 4
Page: [1]