Mail Archive Search: <+subject:/^(?:^\s*(re|sv|fwd|fw)[\[\]\d]*[:>-]+\s*)*Tie\-rod\s+end\s+tightness\s*$/>

Results:

References: [ +subject:/^(?:^\s*(re|sv|fwd|fw)[\[\]\d]*[:>-]+\s*)*Tie\-rod\s+end\s+tightness\s*$/: 4 ]

Total 4 documents matching your query.

1. Tie-rod end tightness (score: 1): Author: Unknown; Date: Sat, 10 Apr 2004 20:00:31 -0400; When installing new tie-rod ends today, I found I could tighten three of the four to about 25 lb-ft but the fourth [an inner] would not because the shaft would turn. I would have thought the shaft wo; /html/triumphs/2004-04/msg00316.html (7,020 bytes)
2. RE: Tie-rod end tightness (score: 1): Author: Unknown; Date: Sat, 10 Apr 2004 19:09:31 -0700; Use a pry-bar to force the tie-rod end firmly into the center link while tightening the nut. If that won't give you enough friction to turn the nut on the threads, then I would suspect something is; /html/triumphs/2004-04/msg00317.html (6,721 bytes)
3. Re: Tie-rod end tightness (score: 1): Author: Unknown; Date: Sun, 11 Apr 2004 14:15:39 +1200 6.5.1|January 21, 2004) at 11/04/2004 14:15:43, Serialize complete at 11/04/2004 14:15:43; have thought the shaft would seat tightly not specify any torque on these, but the nut >on one side is further about two or three turns more on the shaft than the other. They have new nyloc nuts and; /html/triumphs/2004-04/msg00318.html (7,463 bytes)
4. Re: Tie-rod end tightness (score: 1): Author: Unknown; Date: Sat, 10 Apr 2004 22:29:34 EDT; In addition to other excellent advice you've already received, I'll offer one additional suggestion. You might try drawing down the tie rod end with a NON-nyloc nut first to seat it in the taper, and; /html/triumphs/2004-04/msg00319.html (7,453 bytes)

Current List: 1 - 4
Page: [1]