Mail Archive Search: <+subject:/^(?:^\s*(re|sv|fwd|fw)[\[\]\d]*[:>-]+\s*)*What\s+parts\s+are\s+required\s+for\s+tranny\s+rebuild\s*$/>

Results:

References: [ +subject:/^(?:^\s*(re|sv|fwd|fw)[\[\]\d]*[:>-]+\s*)*What\s+parts\s+are\s+required\s+for\s+tranny\s+rebuild\s*$/: 5 ]

Total 5 documents matching your query.

1. What parts are required for tranny rebuild (score: 1): Author: Tracy Drummond <bighealey@charter.net>; Date: Wed, 07 Apr 2004 07:51:45 -0700; If no gears are required, what parts shall I expect to ALWAYS replace when rebuilding a sideshift tranny. I expect: bearings needle bearings ? thrust washers? gasket kit syncros (who has the hardened; /html/healeys/2004-04/msg00195.html (7,195 bytes)
2. RE: What parts are required for tranny rebuild (score: 1): Author: "Peter Schauss" <schauss@worldnet.att.net>; Date: Wed, 7 Apr 2004 21:33:53 -0400; If the gearbox is not making any serious noises or jumping out of gear, you can get by with: gasket set front seal syncro rings third motion shaft bearing throwout bearing clutch plate rear mounts ru; /html/healeys/2004-04/msg00204.html (8,097 bytes)
3. Re: What parts are required for tranny rebuild (score: 1): Author: "Chris Dimmock" <cd3000@bigpond.net.au>; Date: Thu, 8 Apr 2004 16:35:34 +1000; Hi Tracey And check (ie measure) the detent ball springs, and make sure the detent balls aren't worn. Check the selector forks too. And you'll need shim steel, or correctly sized laygear thrusts to g; /html/healeys/2004-04/msg00216.html (9,536 bytes)
4. Re: What parts are required for tranny rebuild (score: 1): Author: Tracy Drummond <bighealey@charter.net>; Date: Thu, 08 Apr 2004 05:56:55 -0700; Here is my new shopping list for the tranny rebuild to correct 3rd and 4th gear syncros problem. Pilot Bush Clutch disk Release bearing clutch fork boot Spring, clutch pedal return oil seal Gasket Se; /html/healeys/2004-04/msg00221.html (10,607 bytes)
5. RE: What parts are required for tranny rebuild (score: 1): Author: "Vink, Graham" <vinkg@fleishman.com>; Date: Thu, 8 Apr 2004 09:17:31 -0500; Hello list, Have followed this thread with interest. Two questions: -Are the parts requirements similar for a center-shift tranny? -Is a center-shift tranny easier/harder to rebuild than a side-shift; /html/healeys/2004-04/msg00224.html (11,212 bytes)

Current List: 1 - 5
Page: [1]