- 1. Wheel cylinder rebuild (score: 1)
- Author: Adam Bradley <ambradley@yahoo.com>
- Date: Mon, 25 Feb 2002 19:30:54 -0800 (PST)
- I am rebuilding my wheel cylinders. After honing, do I need to lubricate the cylinders or pistons with anything when I put the inner seal and piston back in or should I reassemble them dry? P.S.: Any
- /html/datsun-roadsters/2002-02/msg01135.html (7,243 bytes)
- 2. Re: Wheel cylinder rebuild (score: 1)
- Author: "Fred Schroeder" <roadster@texoma.net>
- Date: Mon, 25 Feb 2002 22:10:24 -0600
- Wet it down with brake fluid. Best regards, Fred Schroeder Denison, TX SRL311-13359 TDROC Reg e-mail sitsinwest@texoma.net Home page http://home.texoma.net/~sitsinwest -- Original Message -- From: "A
- /html/datsun-roadsters/2002-02/msg01136.html (8,237 bytes)
- 3. Re: Wheel cylinder rebuild (score: 1)
- Author: R Haug <haugchiro@moscow.com>
- Date: Mon, 25 Feb 2002 20:13:16 -0800
- Adam, Just use some brake fluid. It lubricates just fine. Makes it a bit easier to put together. Bob /// datsun-roadsters@autox.team.net mailing list
- /html/datsun-roadsters/2002-02/msg01137.html (7,044 bytes)
- 4. Re: Wheel cylinder rebuild (score: 1)
- Author: "James M Koken" <james.m.koken@gte.net>
- Date: Mon, 25 Feb 2002 21:39:01 -0800
- I always use brake fluid to promote a good seal with the new cups and the honed cyl. walls. Mike Koken Colo. Springs. Coooooold! -- Original Message -- From: "Adam Bradley" <ambradley@yahoo.com> To:
- /html/datsun-roadsters/2002-02/msg01139.html (8,130 bytes)
- 5. Re: Wheel cylinder rebuild (score: 1)
- Author: "datsunmike" <datsunmike@nyc.rr.com>
- Date: Tue, 26 Feb 2002 06:44:44 -0500
- The aluminum rear wheel cylinders? You can't hone aluminum as it was anodized from the factory to seal and harden the bores. Aluminum is too porous and soft in its natural state without the hardening
- /html/datsun-roadsters/2002-02/msg01143.html (8,331 bytes)
This search system is powered by
Namazu