- 1. rear hub pulling question (score: 1)
- Author: "Evangelos G. Makris" <emakris@hol.gr>
- Date: Fri, 04 Jun 1999 04:50:31 +0300
- I am trying to remove the rear hubs on a Sprite with solid wheels. Could you please tell me what the central bolt of the "generic hub puller" should lever against? Is this a "special" tool or is ther
- /html/spridgets/1999-06/msg00291.html (7,413 bytes)
- 2. Re: rear hub pulling question (score: 1)
- Author: Ulix Goettsch <ulix@u.washington.edu>
- Date: Fri, 4 Jun 1999 08:02:55 -0700 (PDT)
- A big washer that fits right on teh axle tube. The center bolt then sits in the hole in the middle of the washer. The inner bolts on the front A-arms have big washers on them with a little arm on the
- /html/spridgets/1999-06/msg00303.html (8,664 bytes)
- 3. Re: rear hub pulling question (score: 1)
- Author: Shawn Knight <eybdoogy@earthlink.net>
- Date: Fri, 04 Jun 1999 14:05:41 -0400
- To use a generic two arm puller: Put a large wrench over the centre of the hub. The arbor will press against this. A third hand makes this much easier. This job is frustrating if you are using two ha
- /html/spridgets/1999-06/msg00309.html (8,554 bytes)
- 4. Re: rear hub pulling question (score: 1)
- Author: Frank Clarici <spritenut@Exit109.com>
- Date: Fri, 04 Jun 1999 17:30:41 -0400
- Evangelos Like Ulix said, a big washer works for me. -- Frank Clarici Toms River, NJ Bugeye Sprite 67 Sprite 59 A40 http://www.exit109.com/~spritenut/
- /html/spridgets/1999-06/msg00319.html (8,411 bytes)
- 5. Re: rear hub pulling question (score: 1)
- Author: "Angela Hervey-Tennyson & Peter Westcott" <toobmany@bigpond.com>
- Date: Sat, 5 Jun 1999 22:20:21 +1000
- What I do is to reverse the half shaft onto the studs so the long spiky bit pokes outwards. A couple of wheel nuts can then be threaded onto the studs and alternately tightened. The hub will then gen
- /html/spridgets/1999-06/msg00334.html (8,117 bytes)
- 6. Re: rear hub pulling question (score: 1)
- Author: "Mike Gigante" <mikeg@vicnet.net.au>
- Date: Sun, 6 Jun 1999 12:24:28 +1000
- Similar to Peter I used of the the flanges of a broken half shaft before I got my puller. Now I use the ace hub nut spanner I got from Bob Gilll and use the puller to press against that (a tyre lever
- /html/spridgets/1999-06/msg00362.html (9,344 bytes)
This search system is powered by
Namazu