Search String: Display: Description: Sort:

Results:

References: [ +subject:/^(?:^\s*(re|sv|fwd|fw)[\[\]\d]*[:>-]+\s*)*\[Healeys\]\s+MKII\s+BJ7\s+Gearbox\s+Rebuild\?\?\?\?\s*$/: 5 ]

Total 5 documents matching your query.

1. [Healeys] MKII BJ7 Gearbox Rebuild???? (score: 1)
Author: Jeff Capezzuti <jcapezzuti@aol.com>
Date: Sun, 29 May 2011 22:19:32 -0400
I am in the beginning stages of planning to rebuild my original Gearbox. The synchros are wearing out, and have never been replaced. Does anyone have any advice they'd be willing to share? I have a f
/html/healeys/2011-05/msg00681.html (8,668 bytes)

2. Re: [Healeys] MKII BJ7 Gearbox Rebuild???? (score: 1)
Author: I Erbs <eyera3@gmail.com>
Date: Sun, 29 May 2011 19:43:17 -0700
Tranny comes out by itself. Up and out of the passenger compartment take too many photos Replace clutch assembly. Add rear main seal kit Resurface and or lighten your flywheel. check ring gear for ch
/html/healeys/2011-05/msg00685.html (10,320 bytes)

3. Re: [Healeys] MKII BJ7 Gearbox Rebuild???? (score: 1)
Author: "Dave Porter" <frogeye@porterscustom.com>
Date: Mon, 30 May 2011 06:36:11 -0600
Inspect dog cogs adjacent to the synchros for abnormal shapes and wearing, inspect lay gear shaft for bearing erosion. Large chips on the straight cut 1st gear should probably be replaced. Most other
/html/healeys/2011-05/msg00693.html (8,808 bytes)

4. Re: [Healeys] MKII BJ7 Gearbox Rebuild???? (score: 1)
Author: "Herbert Miller" <hgmiller3@qwest.net>
Date: Mon, 30 May 2011 11:56:26 -0500
The following applies to the side shift gearbox, but I assume the center shift would be the same. When you remove the transmission from the bellhousing be sure to retain and identify the end play shi
/html/healeys/2011-05/msg00712.html (14,163 bytes)

5. Re: [Healeys] MKII BJ7 Gearbox Rebuild???? (score: 1)
Author: "Peter Schauss" <rpschauss@gmail.com>
Date: Mon, 30 May 2011 08:19:21 -0400
1.) You can pull the gearbox without pulling the engine. You will have to remove the seats, carpeting, and parcel shelf. Then you will need to disconnect the hand brake cable underneath the car so th
/html/healeys/2011-05/msg00713.html (11,637 bytes)


This search system is powered by Namazu