Mail Archive Search: <+subject:/^(?:^\s*(re|sv|fwd|fw)[\[\]\d]*[:>-]+\s*)*\[Healeys\]\s+starting\s+problem\s*$/>

Results:

References: [ +subject:/^(?:^\s*(re|sv|fwd|fw)[\[\]\d]*[:>-]+\s*)*\[Healeys\]\s+starting\s+problem\s*$/: 15 ]

Total 15 documents matching your query.

1. [Healeys] starting problem (score: 1): Author: "Dr. C. Rubino" <ruvino@ripnet.com>; Date: Fri, 30 Apr 2010 11:35:58 -0400; is a lag before the starter fully engages-like a "umph" than then it turns over. Battery is fully charged. New starter ground cable. Any suggestions? Carl BN-4(L) ___________________________________; /html/healeys/2010-04/msg00673.html (7,179 bytes)
2. Re: [Healeys] starting problem (score: 1): Author: Bob Spidell <bspidell@comcast.net>; Date: Fri, 30 Apr 2010 15:57:09 +0000 (UTC); Sounds like the starter solenoid is flaky. bs -- Bob Spidell - San Jose, CA is a lag before the starter fully engages-like a "umph" than then it turns over. Battery is fully charged. New starter grou; /html/healeys/2010-04/msg00675.html (7,359 bytes)
3. Re: [Healeys] starting problem (score: 1): Author: Oudesluys <coudesluijs@chello.nl>; Date: Fri, 30 Apr 2010 18:32:16 +0200; The starter solenoid seems to be a bit sticky and the contacts engage only after the mechanical resistance in the solenoid has been overcome. Renew or take apart, clean and rebuild if you can. Kees O; /html/healeys/2010-04/msg00678.html (8,473 bytes)
4. Re: [Healeys] starting problem (score: 1): Author: "Dave Porter" <frogeye@porterscustom.com>; Date: Fri, 30 Apr 2010 11:17:50 -0600; Also likely that the starter motor commutator is worn or brushes are nearly dp frogeye@porterscustom.com Porter Customs 2909 Arno NE Albuquerque, NM USA 87107 505-352-1378 1954 BN2 1959 AN5 Porter Cu; /html/healeys/2010-04/msg00682.html (8,586 bytes)
5. [Healeys] starting problem (score: 1): Author: <healeymanjim@hansencc.net>; Date: Sat, 11 Jun 2011 04:38:54 +0000; have noticed the past few months that many times when the starter on the bj8 spins it will not start till i let off the key from the start position. does not do it all the time, but enough to get me; /html/healeys/2011-06/msg00271.html (7,139 bytes)
6. Re: [Healeys] starting problem (score: 1): Author: Bob Spidell <bspidell@comcast.net>; Date: Fri, 10 Jun 2011 22:38:13 -0700; Don't understand this ... when you move the key from the start position the engine would quit turning over. Are you saying that's when it starts? My SWAG is battery--even though it turns the engine; /html/healeys/2011-06/msg00272.html (7,768 bytes)
7. Re: [Healeys] starting problem (score: 1): Author: Oudesluys <coudesluijs@chello.nl>; Date: Sat, 11 Jun 2011 10:03:26 +0200; This is often an ignition problem. During starting the voltage drops hence a lesser spark. Check / clean / regap / renew spark plugs and points. Also have the battery checked and check the earth stra; /html/healeys/2011-06/msg00275.html (7,039 bytes)
8. Re: [Healeys] starting problem (score: 1): Author: "Niels Bengaard" <bengaard@850r.dk>; Date: Sat, 11 Jun 2011 12:37:57 +0200; Try checking if you got spark at all during startup. I had a similar problem and it was the electric cut off switch in the trunk. The power to ignition from the switch is seperate from the power to t; /html/healeys/2011-06/msg00279.html (8,488 bytes)
9. Re: [Healeys] starting problem (score: 1): Author: Michael Oritt <michael.oritt@gmail.com>; Date: Sat, 11 Jun 2011 07:42:15 -0400; The switch does not provide apportion power or provide it to the ignition--it both makes or breaks the car's ground and grounds or not the coil. If you have to play with the switch's position in ord; /html/healeys/2011-06/msg00280.html (9,929 bytes)
10. Re: [Healeys] starting problem (score: 1): Author: David Nock <healeydoc@sbcglobal.net>; Date: Sat, 11 Jun 2011 07:28:25 -0700; You probably have bad connection in the ignition switch. When you crank the engine check for power at the white wire on the fuse box. David Nock British Car Specialists Stockton Ca www.britishcarspec; /html/healeys/2011-06/msg00282.html (8,401 bytes)
11. [Healeys] starting problem (score: 1): Author: "Dr. C. Rubino" <ruvino@ripnet.com>; Date: Wed, 10 Aug 2011 17:46:00 -0400; Car reluctant to start. Very little juice. Went to put on battery charger and noticed that positive connector was quite warm. Something in the back of my mind says I should know what this means. But; /html/healeys/2011-08/msg00233.html (7,379 bytes)
12. Re: [Healeys] starting problem (score: 1): Author: Chris Dimmock <austin.healey@gmail.com>; Date: Thu, 11 Aug 2011 08:13:54 +1000; Heat is due to increased resistance. Clean the terminals and the battery posts. Best Chris Sent from my iPhone http://autox.team.net/mailman/options/healeys/austin.healey@gmail.com _________________; /html/healeys/2011-08/msg00235.html (8,300 bytes)
13. Re: [Healeys] starting problem (score: 1): Author: David Nock <healeydoc@sbcglobal.net>; Date: Wed, 10 Aug 2011 15:40:22 -0700; Any time a electrical connection is hot or warm to the touch that is a poor connection that can cause a slow crank of hard start David Nock British Car Specialists Stockton Ca 95205 209-948-8767 www.; /html/healeys/2011-08/msg00236.html (8,377 bytes)
14. Re: [Healeys] starting problem (score: 1): Author: Richard Ewald <richard.ewald@gmail.com>; Date: Wed, 10 Aug 2011 18:10:45 -0700; To add to David's post with battery cables due to corrosion they can build resistance internally. After you clean the connections if the cables are still warm this would indicate resistance in the ca; /html/healeys/2011-08/msg00237.html (9,433 bytes)
15. Re: [Healeys] starting problem (score: 1): Author: Oudesluys <coudesluijs@chello.nl>; Date: Thu, 11 Aug 2011 09:22:45 +0200; Look for corroded or loose battery terminals/clamps first, check terminal leads for damage. If all OK, have the battery checked, could be an internal short. Kees Oudesluijs NL [demime 1.01d removed a; /html/healeys/2011-08/msg00241.html (7,104 bytes)

Current List: 1 - 15
Page: [1]