Adam,
Don't need a spring compressor for the rear. Make
sure the e-brake is not set. You must turn the axles
in order for the trailing arm to drop fully. This
should be enough to get the springs out.
I went through this little battle once. Then I
decided to look at the Bentley book. Couldn't figure
out why it said to release the e-brake....
Todd Bermudez
TR250
74TR6
--- Adam C Beasley <adam@adambeasley.com> wrote:
> I'm wanting to replace my rear springs with uprated
> ones. I tried to remove
> the spring without a spring compressor but the arm
> won't drop low enough.
> Is there an easy and cheap way to create a spring
> compressor?
>
>
>
> Thanks,
>
>
>
> Adam
>
> 73 TR6
>
__________________________________
The all-new My Yahoo! - Get yours free!
http://my.yahoo.com
|