Here is a link that I saved for Harmonic Balancer
rebuild. I've never used them, so I can't vouch for
their work.
http://www.dalemfg.com/harmonicbalancer_002.htm
Jim
> Jim Richards wrote:
> I took an engine from my junk 76 TR6 to the machine
> shop to see if it
> was an acceptable core. After the inspection it was
> deemed to be a good
> one. Six months later, most of the work has been
> done.
>
> While dialing-in the cam timing, the machinist
> determined that the scale
> on the harmonic balancer had shifted on the pully (
> 8-10 degrees). A
> mark on the flywheel that lines up with the back
> engine plate was right
> on.
> I'm not sure that I've heard of this "shift" before.
> Has anyone else
> experienced this? I would assume that the remedies
> would be to replace
> or restore the balancer.
> Where might someone have a balancer restored? Is
> this something that
> might be swapped with another used one? Are used
> ones generally
> reliable?
> Thanks in advance,
>
> Jimmy Richards
>
____________________________________________________
Start your day with Yahoo! - make it your home page
http://www.yahoo.com/r/hs
|