6pack
[Top] [All Lists]

Re: [6pack] Re: [TR] Cleaning Aluminum

To: DLylis@aol.com
Subject: Re: [6pack] Re: [TR] Cleaning Aluminum
From: Robert Lang <lang@isis.mit.edu>
Date: Tue, 23 Oct 2007 10:34:03 -0400 (EDT)
On Tue, 23 Oct 2007 DLylis@aol.com wrote:

> One thing to keep in mind when cleaning the tranny.  You can make it  look
> like a jewel if you like.  Degreaser and a power washer will make it  look 
>good.
> If you make it look like a jewel you are then going to bolt it  up behind
> the motor that, more likely than not, leaks oil, and it will  quite rapidly 
>just
> look good.
> But then, that's just my experience.

My experience is quite the opposite. When I build a motor, it typically 
does not leak a drop. In fact, drips from either of my TR6's indicate that 
there's a problem.

Plus - I hate getting filthy taking the tranny in/out or when working on 
the motor.

I like to stay "ahead" of the problems if I can. Along those lines, I'll 
probably pull the motor out of the street car over the winter. 130k miles 
on the original pistons / bores and I finaly can't get ahead of the 
leakdown past the rings... that blowby makes the front seal leak quite a 
bit.

> David  Lylis
> 69 TR6 CC26160L
> 60 TR3A TS74461LO

regards,
rml
---------------------------------------------------------------------------
Bob Lang              Room N42-140Q            |  This space for rent
Consultant            MIT IS&T unix-linux-help |
Voice:617-253-7438    FAX: 617-258-9535        |  Cell: 339-927-4489
---------------------------------------------------------------------------




<Prev in Thread] Current Thread [Next in Thread>