alpines
[Top] [All Lists]

Re: Stinko!

To: SJC Worldwide <rootes@ix.netcom.com>,
Subject: Re: Stinko!
From: Bob Palmer <rpalmer@ames.ucsd.edu>
Date: Fri, 25 Aug 2000 10:21:06 -0700
Steve,

The Tiger 260 is rated, according to the Shop Manual, at only 164 BHP 
gross, 136 BHP net. I assume you plugged the Tiger weight into the G-tech 
Pro, but does it also compensate for drive train losses that may be of the 
order of 10-20% ? Or is it just coincidence that the G-tech and the 
advertised BHP are only off by 6 BHP? It's pretty easy to get 300+ HP out 
of a 260, but not without spending the better part of $3,400 - and a lot 
more effort too. Is yours an original, matching #, unopened 260? The 
arguments in favor of keeping the 260 are the originality factor,and the 
five-bolt to six-bolt housing swap and the other pieces at the front end of 
the motor that also need to be swapped that add to the cost and effort of 
installing the crate motor. On the other hand, a 345 HP roller cam motor is 
hard to beat and would be a lot more driveable than a 260 at anywhere near 
the same horsepower. You can probably find a slightly used or even new one 
at less than $3,400 if you look in the right places.

Bob



At 05:24 PM 8/24/00 -0700, SJC Worldwide wrote:

>Here's another question for the Tiger list. I'm going to change out the
>motor from its pretty anemic 260 to a 289 or 302. What have you guys
>done with a medium budget to up the horsepower and torque with a 289 or
>302? Since I had my car tested with a "G-Force" device and it apparently
>puts out a massive 158 net HP, I'll be real happy to get around 300 HP
>or so. I talked to a Tiger owner today who had put in a 345HP Ford
>Motorsport "crate" motor, cost $3400, and he was raving about how fast
>it is and that it still idles pretty smoothly with a Holly 600. Of
>course I wouldn't mind spending less if I can.
>
>Regards,
>Steve Sage


<Prev in Thread] Current Thread [Next in Thread>
  • Stinko!, SJC Worldwide
    • Re: Stinko!, Bob Palmer <=