Re: Convertible Top Installation Question

[Jody Levine <jody.p.levine@hydro.on.ca>]

tooze@vinny.cecer.army.mil (Marcus Tooze) wrote:
>The rivet gun is fine from VB BUT:

You can probably get one at any hardware store as well.

>2) The rivets supplied are not long enough...I had to go out and by
>some with a longer reach.

I had this problem with the TR7's new top. The rivets that came with
the top were fine for where there was one layer of vinyl/metal, marginal for
two layers of vinyl and impossible for three or four. It's always handy to
have a good assortment of rivets around anyway.

Jody