hot off the press!!! datsun roadster front floor panel patch with proper
ribbing as per factory. 20 inches wide by 19 inches long. Rocker side
has edge folded over to butt up to inner rocker face, ribs match up with
tunnel ribs. the length takes you to the large hump on the floor in
front of the seat.
$80/pair one right one left
This pattern can be made to patch under the seats also. The ribbing
allows for strength and prevents oil canning that flat panels create.
the ribbing is one large(closest to firewall) and then two smaller
channels.
Rocker panels should be ready by mid-January.
Rear quarter trunk floor sections by mid-February
Front fender inner braces by mid-March
Need a trunk floor patch, an inner fender nose or channel? we now have
dipped original panels that have been repaired and ready for install.
Door post bottoms and front valances are now in stock. Need to fill
those horrible speaker holes in the trunk/parcel shelf divider? we have
the pieces to make the job seamless.
cad plated items now in stock:
1500/1600 carb overflow tubes, full length $18 ea
1500/1600 metal fuel line from fuel pump to tee $24
fuel filler metal tube rear $15
67.5 windshield washer bag bracket $40
head light bucket and rings to hold lens in, with screws $45(no rubber
or light)
1600 heat shield $25
horn relay cover $5
reconditioned 69-70 head light relay assembly $30
reconditioned sharp edged head light relay ass $30
reconditoned horn relay assembly $10
master cylinder clamps 3/$2
late rear door post latch(what door latch mates to) $6 ea
front door post to door latch(keeps door from opening too much and
damaging the side molding) $20 ea
engine room voltage regulator cover $10
hood release female latch assembly(state year) $25
male hood release mechanism(state year) $20
coil bracket $8
--
Ross Mullen
SPORTS IMPORTS - your Datsun Roadster Parts House
Phone: (604) 538-5615
FAX: 535-3538
Web site: http://home.istar.ca/~datsun
|