I replaced my dist. oil line with standard steel braided line. I had to tap
the block out to 1/8 NPT in order to use standard NAS fittings and used a
compression fitting on the hard line going to the guage. I used standard -3
fittings. (if my memory serves me correctly)
I have a question- someone mentioned a restrictor adapter on the original hose.
Is this an inline orifice to reduce flow to the distributor (so it doesn't
pull too much oil away from the bearings)?
Will I be ok without the restrictor or orifice?
John Over
68 2000
67 1600
|