Points - needs ballast resistor
Pertronix - needs ballast resistor
EI dizzy with stock coil - needs ballast resistor
EI dizzy with 12V coil - NO ballast resistor
Stock or EI dizzy with MSD/Crane etc. and 12V coil - NO ballast resistor (I
don't think a stock coil would be wise with this setup so don't even try
it!)
Clear enough??
Daryl
----- Original Message -----
From: "Eddie" <eddietude@socal.rr.com>
> Wait a sec, I'm confused...
>
> Someone else sent me this info:
>
> "just to clarify, if you remove the resistor, you can use the same
> ignition coil for points and hei. "
>
> So, which is it?
> Eddie
>
>
> Peter Harrison wrote:
>> Recent experience
>>
>> Depending upon the coil - need ballast resistor - or not - make sure that
>> you specify that you are using electronic - i had a lucas coil that
>> worked fine - when i changed i forget to mention - thus fried ignition -
>> now ok
>>
>> Peter
________________________________________
Support Team.Net http://www.team.net/donate.html
Datsun-roadsters mailing list
http://www.team.net/archive
http://autox.team.net/mailman/listinfo/datsun-roadsters
|