Dizzy is short for distributor.
Linda
-----Original Message-----
From: Eddie <eddietude@socal.rr.com>
To: Daryl Smith <drlsmith@dccnet.com>
Cc: Datsun@autox.team.net; List <datsun-roadsters@autox.team.net>
Sent: Sun, 12 Apr 2009 10:37 pm
Subject: Re: [Roadsters] Ignition coil
Not exactly....?
?
IE "dizzy"? What's a "dizzy"? ?
Why does the stock coil need a resistor but the 12v does not? ?
Eddie?
?
Daryl Smith wrote:?
> Points - needs ballast resistor?
> Pertronix - needs ballast resistor?
> EI dizzy with stock coil - needs ballast resistor?
> EI dizzy with 12V coil - NO ballast resistor?
> Stock or EI dizzy with MSD/Crane etc. and 12V coil - NO ballast
> resistor (I don't think a stock coil would be wise with this setup so
> don't even try it!)?
>?
> Clear enough???
>?
> Daryl?
>?
>?
> ----- Original Message ----- From: "Eddie" <eddietude@socal.rr.com>?
>?
>> Wait a sec, I'm confused...?
>>?
>> Someone else sent me this info:?
>>?
>> "just to clarify, if you remove the resistor, you can use the same
>> ignition coil for points and hei. "?
>>?
>> So, which is it??
>> Eddie?
>>?
>>?
>> Peter Harrison wrote:?
>>> Recent experience?
>>>?
>>> Depending upon the coil - need ballast resistor - or not - make sure
>>> that you specify that you are using electronic - i had a lucas coil
>>> that worked fine - when i changed i forget to mention - thus fried
>>> ignition - now ok?
>>>?
>>> Peter?
________________________________________?
Support Team.Net http://www.team.net/donate.html?
?
You are subscribed as ljordan704@netscape.net?
?
Datsun-roadsters mailing list?
?
http://www.team.net/archive?
?
http://autox.team.net/mailman/listinfo/datsun-roadsters?
________________________________________
Support Team.Net http://www.team.net/donate.html
Datsun-roadsters mailing list
http://www.team.net/archive
http://autox.team.net/mailman/listinfo/datsun-roadsters
|