fot
[Top] [All Lists]

Re: shafted

To: goodparts@desupernet.net, fot@autox.team.net
Subject: Re: shafted
From: Vitesse63@aol.com
Date: Wed, 22 May 2002 19:54:55 EDT
In a message dated 5/22/02 6:05:15 PM Central Daylight Time,
goodparts@desupernet.net writes:

> Subj: Re: shafted
> Date: 5/22/02 6:05:15 PM Central Daylight Time
> From:    goodparts@desupernet.net (Richard Good)
> To:    Vitesse63@aol.com
>
> File:cat6-02.doc (89088 bytes) DL Time (44000 bps): < 1 minute
>
> Hi Leon,
>
> Sorry to hear of your rocker shaft woes. What you really need to do is get
> rid of the bushings and use needle bearings. I make rockers with needle
> bearings at the shaft and at the roller in
> 1.55:1 or 1.65:1 ratio. They are CNC machined out of 7075T6 aluminum and
> anodized gold color. I also make a hard shaft to work with the needle
> bearing. This shaft does not have the proper
> oiling configuration, however, to work with bushings. A hard shaft and a
> set of "rockers only" for you to assemble using your adjusters, pedestals,
> spacer springs, etc. sells for $578 US. A
> complete assembly ready to bolt on is $669. They are in stock.
>
> I have attached my catalog page on rockers.
>
> Regards,
> Richard Good
> Good Parts
>
> Thanks Richard,

As previously stated, I already have a set of Roller Rockers from Ted
Schumacher, and I need a good quality shaft to go with them.

The rockers that I have, are presently still 'in shipping' from the UK.
I expect them to reach me by about the end of next week.

Do you supply rocker shafts alone suitable for the GT6+ ?

Regards

Lion

<Prev in Thread] Current Thread [Next in Thread>