| To: | "Jack W. Drews" <vinttr4@geneseo.net>, <fot@autox.team.net> |
|---|---|
| Subject: | RE: Figure 8 survey results |
| From: | "Brad Eells" <bradlnss@lightspeed.net> |
| Date: | Mon, 3 Mar 2003 18:12:20 -0800 |
Uncle Jack, Question: Are the Figure 8 gaskets available in various thicknesses? I have lots of them from various gasket sets in steel, copper and composite of some sort. What would you do if #1 cylinder measures out and #2 doesn't? Cut them in to o-rings and use different thicknesses? Is thicknesses a word? Brad 62 TR4 << and then use figure 8's of whatever thickness is needed to give the proper protrusion, >> |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Figure 8 survey results, Jack W. Drews |
|---|---|
| Next by Date: | Figure 8 survey results, n197tr4 |
| Previous by Thread: | Figure 8 survey results, Jack W. Drews |
| Next by Thread: | Figure 8 survey results, n197tr4 |
| Indexes: | [Date] [Thread] [Top] [All Lists] |