I have an uprated oil pump shaft from them (the short one that goes
into the rotor). It only has splines to press it into the rotor and
the machining of the slot at the top still has sharp edges - no
radius. I was a little disappointed to see that. So far, I am only
keeping it as a spare. Joe(B)
----- Original Message -----
From: "Jack W. Drews" <vinttr4@geneseo.net>
To: <fot@autox.team.net>
Sent: Saturday, September 06, 2003 9:04 AM
Subject: oil pump rotors
> Cambridge Motorsports sells both an uprated oil pump drive shaft -
the ne
> that goes up to the gear, and a special pump shaft. I haven't tried
either. see
>
> http://www.cambridgemotorsport.com/index2.cfm
>
> uncle jack
|