Assuming you have a GT6 Mk II or III type block then you can fit a TR6
head - once you've hacksawed about 1/4" of it.
John Kipping
----- Original Message -----
From: "Scott Janzen" <s.janzen@comcast.net>
To: "Bill Babcock" <BillB@bnj.com>; "'Jack W. Drews'" <vinttr4@geneseo.net>;
<fot@autox.team.net>
Sent: Wednesday, July 21, 2004 5:39 AM
Subject: Looking for an engine for a GT6 , almost any condition
> I want to build up a second engine for my '68 GT6, and I figured I
> better start now if I want to be ready next spring. I don't really need
> anything other than the basic long block and head and internals - don't
> need carbs, starter, generator, or any accessories. Actually, I even have
a
> block and crank, so I would settle for just a complete head assembly.
> Also, I plan to put a triple Weber set-up on this one. Anyone have
the
> whole set-up or just the manifold, or know where to get the manifold?
>
> Looking for stuff in the northeast, ideally, so the shipping/travel
is
> not too bad.
>
> E-mail me (s.janzen@comcast.net) and let me know what you have and
> what you want for it.
>
> Thanks!
|