I cut a hole in the lower valance with a sabre saw, got some stainless
screen from Pegasus, put chrome door edging around the hole, pop riveted
the screen to the valance with large head pop rivets with washers on the
back, and painted the pop rivet heads to match the car.
At 03:51 PM 8/1/2004, Don Marshall wrote:
>I guess it's time to move the oil cooler from inside the radiator shroud
>down to the valance where everyone else seems to have theirs. Before I
>start cutting, is there a source for premade grills or do we all just
>use hardware store screening? Also, once the hole is cut, is there any
>tried and true mounting technique or do we just figure it out from
>scratch? I suspect someone on FOT has done lots of these before.
>
>Thanks, Don
uncle jack
|