either kerosene or gasoline,a lot of well soaked rags, and a heat gun or hair
dryer,and a lot of elbow grease....use the heat gun first to soften it up(not
while gas is fresh)...then soak rags ,a lot and rub on,will take multiple
coats but once its started will go easier each successive step...if really
thick
areas use a scraper to get the big gunk off and the outer hard layer....it's
basically a tar so petroleum distllate basses are needed to dissolve it
=== unsubscribe/change address requests to majordomo@autox.team.net
|