I seem to recall that you ran a balance bar pivoted for more
pedal ratio than the ridiculously low stock (ca. 3.5:1 I think).
Will you have enough pedal travel with the new m/cylinders?
Shane Ingate in Maryland
>I have a TR6 front disk, rear drums. The fronts are now Toyota [4 pot,
>slightly more fluid volume] and the rear master cylinders area 7/8 inch
>[from Morgan via Viccy Brit]. I have .75 Tilton dual master cylinders.
>pedal pressure is really too hard for my liking. In my new 250, I have
>decided to use 5/8 master cylinder on the rears and .70 on the fronts.
>be some time till I can report on the results