fot
[Top] [All Lists]

[Fot] checking bearing clearances

To: <fot@autox.team.net>
Subject: [Fot] checking bearing clearances
From: "Scott Janzen" <S.Janzen@comcast.net>
Date: Mon, 28 Jan 2008 14:18:57 -0500
One builder I know installs the bearings in the rod ends or mains, torques the
caps and uses an inside micrometer to check bearing clearances before
installing the rods or crank.
Another one swears that method is not sufficient and you have to use
plastigauge.
What says the group?
_______________________________________________
http://www.team.net/donate.html

Fot mailing list
Fot@autox.team.net
http://autox.team.net/mailman/listinfo/fot

<Prev in Thread] Current Thread [Next in Thread>