I am looking for a CRANE breakerless ignition for my AMBRO.
Thanks!? Joe A
-----Original Message-----
From: Greg & Alison Blake <ablake2@austin.rr.com>
To: 'Joe Boruch' <jaboruch@netzero.net>
Cc: fot@autox.team.net
Sent: Wed, 8 Apr 2009 10:33 pm
Subject: Re: [Fot] Ignitionl issues
I am running an alternator and have not had a problem with the cut-off,
it kills the engine every time. I will go ahead and switch the coil
through a separate ignition switch just to be safe. Some have mentioned
that the coil needs to be fed with a wire that has a resistor in it.
Any idea on what that should be? Currently, I am running full 12v from
the battery. Also, should that resistor be bypassed when the starter is
engaged?
I have checked voltage to the timing light, 12v. The wires are a 8mm
silicon jacket, low resistance wire. They were purchased at Autozone as
a kit that had to be trimmed to fit and then assembled.
Thanks,
Greg
-----Original Message-----
________________________________________________________________________
Email message sent from CompuServe - visit us today at http://www.cs.com
_______________________________________________
Support Team.Net http://www.team.net/donate.html
http://www.fot-racing.com
Fot mailing list
Fot@autox.team.net
http://autox.team.net/mailman/listinfo/fot
|