fot
[Top] [All Lists]

Re: [Fot] TR4-6 wheel stud knurl OD?

To: "J.C. Hassall" <jhassall@blacksburg.net>, fot <fot@autox.team.net>
Subject: Re: [Fot] TR4-6 wheel stud knurl OD?
From: Dennis DeLap <yellow-green@sbcglobal.net>
Date: Wed, 20 Mar 2013 18:50:34 -0500
Delivered-to: mharc@autox.team.net
Delivered-to: fot@autox.team.net
Moroso 46160

-----Original Message-----
From: "J.C. Hassall" <jhassall@blacksburg.net>
Sent: b3/b20/b2013 6:38 PM
To: "fot" <fot@autox.team.net>
Subject: [Fot] TR4-6 wheel stud knurl OD?

Anyone happen to know the OD of the press-in wheel studs for TR4-6?
Most of the p/n I've found are just a tad over the 0.494 ID I've
measured in the hub, so the knurl OD could be a sticky issue.  I need
longer studs in 7/16x20 thread, so need to order larger and drill the
hubs.  Anyone have a favorite p/n?

tnx

jim

--
Jim Hassall
Blacksburg VA
'63 TR4 in autox preparation
99% finished, 90% to go
_______________________________________________
fot@autox.team.net

http://www.fot-racing.com

Archive: http://www.team.net/archive
http://autox.team.net/mailman/options/fot/yellow-green@sbcglobal.net
_______________________________________________
fot@autox.team.net

http://www.fot-racing.com

Archive: http://www.team.net/archive


<Prev in Thread] Current Thread [Next in Thread>