Standard Payen AE330 seems to have worked fine for me. Don't cut it...just use
as is.
Ty
Tyler Thompson l National Account Executive - Public Safety Sector
esri | One International Court | Broomfield, CO 80021
Phone: 303.449-7779 ext. 1-8260, cell: 719.510-1649 |
E-mail: tyler_thompson@esri.com
Sent from my iPad
(Please excuse any errors or typos)
On Aug 29, 2013, at 1:47 PM, Joe Alexander <n197tr4@cs.com> wrote:
> Mark Macy of Macy's Garage is looking for a gasket for 89 mm conversion.
>
> The Protrusion he mentions, I assume to be 3-4 thousandths.
>
> What do you 89 mm racers use?
>
> Thanks!
>
> Sent from my iPad
>
> Begin forwarded message:
>
>> From: Mark Macy <triumph.guru@yahoo.com>
>> Date: August 29, 2013, 2:37:42 PM CDT
>> To: "n197tr4@cs.com" <n197tr4@cs.com>
>> Subject: 89MM head gaskets
>> Reply-To: Mark Macy <mark@macysgarage.com>
>>
>> Hi Joe:
>>
>> Mark Macy here. I have a question which you might have an answer for.
>>
>> We're putting together our first 89mm engine, and I'm having difficulty
> getting the head gasket to seal. Have not fired the engine yet, but it
keeps
> leaking water into the oil from the head gasket. Liners stand proud of the
> block 3-4mm, and the head was resurfaced. Have tried two of the Moss 89mm
> head gaskets and my guess is that the steel rings around the cylinders are
not
> crushing enough to allow the thin "paper" gasket to seal the rest of the
block
> and head. Is there a better gasket available, or am I missing something
> different entirely?
>>
>> Cheers,
>> Mark
> _______________________________________________
> fot@autox.team.net
>
> http://www.fot-racing.com
>
> Donate: http://www.team.net/donate.html
> Archive: http://www.team.net/archive
> Forums: http://www.team.net/forums
> Unsubscribe/Manage:
http://autox.team.net/mailman/options/fot/tylerpthompson@yahoo.com
_______________________________________________
fot@autox.team.net
http://www.fot-racing.com
Archive: http://www.team.net/archive
|