healeys
[Top] [All Lists]

RE: BJ8 choke cable

To: "Dave Carpenter" <d.carpenter7@verizon.net>, healeys@autox.team.net
Subject: RE: BJ8 choke cable
From: "tom felts" <tomfelts@earthlink.net>
Date: Sun, 11 Apr 2004 07:20:52 -0400
I believe Dave that the springs on the chokes should be strong enough to
pull them back.  If not, you may want to get stronger springs.

Tom


> [Original Message]
> From: Dave Carpenter <d.carpenter7@verizon.net>
> To: <healeys@autox.team.net>
> Date: 4/10/04 11:51:10 PM
> Subject: BJ8 choke cable
>
> Hi all,
>
> I was putting the choke cable back through the firewall, and have a 
> question about the block the cables are attached to. The cable coming 
> from the dash slides into the center of the block and the cable stop, 
> then the screw is tightened to hold it. Fine. The two cables to the 
> carbs are slid through the block from the rear, then through the bracket 
> and the sleeves, on out to the carbs. What holds the cable ends in the 
> block? When the choke is pulled, all works fine. When the cable is 
> pushed in, the block slides forward, but the cables don't move, they 
> come out of the block. The PO must have had this happening, because 
> there is a sheet metal thingy bent over the back of the block and held 
> on by the center cable stop screw. This is not in any photos or 
> illustrations, so it can't be right. Should the choke/carb springs be 
> strong enough to pull the cables back and I need to loosen and lube 
> something there? or is it something else I'm not seeing?
>
> Thanks in advance
> Dave & Bobbie
>
> 1960 Bugeye "Little Bits" (See link below)
> http://members.bellatlantic.net/~vze2z49v/bugeye.htm
> 1960 AH3000 "Healey Bits" (in pieces, make offer)
> 1967 AH3000 "Not in Bits"
> Pittsburgh Vintage Grand Prix (See link below)
> http://www.pittsburghvintagegrandprix.com





<Prev in Thread] Current Thread [Next in Thread>