Congrats Scott. If you haven't replaced the rubber slave hose I would do
so and then rebleed (easier said than done on this car) It could be
swelling shut on the inside.
Does this have a servo? Good Luck! Go drive the "A" :)
Mark
----- Original Message -----
From: "Scott Willis" <ahpowered@hotmail.com>
To: <N5572B@aol.com>; <international_investor@yahoo.com>;
<Healeys@autox.team.net>
Sent: Saturday, April 24, 2004 10:18 AM
Subject: She's running. Wow! Loud! But clutch prob.
> I didn't realize how loud the Healey's were while driving. The BN7 has a
new
> stainless system. I'm used to my MGA with stainless exhaust. Which ever
> radio I do choose to install may not be used much. Great sounding exhaust.
>
> I have not gotten very far before the clutch stops working. After I walk
> home to ge the truck and let it sit for a while it begins working agin. It
> sounds like air in system to me but I never see any while bleeding. It is
a
> bear to get my hands in there to even perform the bleeding.
>
> Any other ideas on what may be causing the clutch to stop working after a
> bit of driving and start working again after sitting?
>
> This car has been in a barn for 25-ish years.
>
> Cheers,
> Scott
> Mashed 60 BN7
|