healeys
[Top] [All Lists]

Re: Healey 100 Center Bracket

To: Rich C <richchrysler@quickclic.net>
Subject: Re: Healey 100 Center Bracket
From: John Harper <AH@jharper.demon.co.uk>
Date: Mon, 11 Apr 2005 19:06:50 +0100
Rich

Thank you for the clarification. Sorry to all if my original description 
was unclear.

All the best

>Gentlemen,
>I have in the shop right now quite an early BN1, body #156 build date 
>10 August 1953. The welded on steady bracket to support the bonnet pull 
>handle tabs down to the vertical about 6" forward of the dash. This 
>same bracket spot welded horizontally up under the inner scuttle 
>support also goes back to under the area where the dash mirror mounts 
>with a 90 degree bend to the vertical plane so the steady screw can 
>pass through from the dash, anchored in place with flat, lock and nut.
>In other words it is not two seperate brackets rather it is one piece 
>of metal, spot welded under the scuttle metal, tabbed down at both 
>ends, the forward bend and hole to support the bonnet pull rod, the 
>rear bend to support the dash.
>As John Harper states this was changed at approx. body 3800.
>Rich Chrysler
>
-- 
John Harper




<Prev in Thread] Current Thread [Next in Thread>