Funny that the question has arisen. In my manual, I have written 2 3/16 socket
on the page for replacing the hubs. I was just at Sears yesterday, nut in hand
(No comments out there!!) but they didn't have anything in stock to fit it. I
just spent the last hour and a half trying to get the @#$%^&%^&* bearing out
of the hub and have now decided to take it to a machine shop (after I take the
bolts off), the second trick is where it reads that the spacer must protrude
.001 to .004 inches. That will be a neat trick!
Bill
BJ7
|