I have the same question as Gordy, any insights? This is where where
the harness should travel as it goes from the flasher relay to the LF
headlamp. I can't tell the place it transitions from the engine bay
to the under fender/behind grill areas.
My original harness was too chopped up and spliced to tell what it
should have been. And this is on my too do list for today.
On 5/21/05, email@example.com <firstname.lastname@example.org> wrote:
> I received a picture of the basic harness on the front of the
> chassis; the picture is good, but it doesn't show what I need. I
> don't know what to do with the lengths of wire beyond the clips
> you see on the front of the bulkhead that then run to the lights...
> do they go up over, under or around the "mud flap" ahead of the
> tire, or clip to something, somewhere....or what?
> Thanks again for your assistance through this whole long
> rebuilding process, the end is in sight....but probably with a few
> more hurtles in the track before the finish line...but are these
> projects ever really done?
Patton Dickson - Richmond, TX
'57 A-H 100-Six - http://Austin-Healeys.com