healeys
[Top] [All Lists]

Re: rear wiring harness routing

To: <healeybn7@aol.com>
Subject: Re: rear wiring harness routing
From: "Rich C" <richchrysler@quickclic.net>
Date: Fri, 11 Aug 2006 08:49:33 -0400
Dave,

The main chassis harness carries on along the inboard edge of the left 
chassis rail, the fuel pump wire branching to the pump appropriately. The 
main harness turns up the axle side of the heel board immediately in front 
of the left battery. There it turns to the rear of the car, passing over the 
axle and mounting to a P clip on one of the inboard bump stop bolts, across 
to the trunk bulkhead and goes through the trunk grommet, with the single 
sleeved wire coming back through its grommet and attaching to the battery 
cutoff switch, and the fuel sender wire branching to the tank sender 
terminal.
Inside the boot, the main harness comes across the left box section and down 
into the tool compartment well. There it ends by plugging into the rear 
harness. the rear harnessbranches immediately to the left lamp assembly, the 
main stem of the harness going under the bumper support bracket and 
fastening across the trunk support hoop as shown in the pictures. The two 
black ground eyes will fasten also as shown in the pictures. When the trunk 
is trimmed in the armacord, the top edge of the armacord will virtually hide 
the harness and clips along this edge, as shown in the picture.

Rich Chrysler

----- Original Message ----- 
From: <healeybn7@aol.com>
To: <healeys@autox.team.net>
Sent: Thursday, August 10, 2006 11:25 AM
Subject: rear wiring harness routing


> All.  I am now moving on to installing the rear portion of my new wiring 
> harness.  Can someone tell me or send pics on the exact routing of the 
> harness as it goes up thru the frame into the axle area and then back into 
> the boot?  MK1 BN7.
> As usual, thanks for any info.
>
> Dave

[demime 1.01d removed an attachment of type image/jpeg which had a name of 
P1010054.JPG]

[demime 1.01d removed an attachment of type image/jpeg which had a name of 
P1010015.JPG]

[demime 1.01d removed an attachment of type image/jpeg which had a name of 
P1010017.JPG]

[demime 1.01d removed an attachment of type image/jpeg which had a name of 
P1010062.JPG]




<Prev in Thread] Current Thread [Next in Thread>