Don -
You want to take your tank to a gas tank repair specialist so that they can
repair it properly and pressure test it. If you don't want to go through
the trouble, then get a new tank. I think a new tank is probably a better
bet anyway.
Alan
'52 A90
'53 BN1
'64 BJ8
On 10/10/06, Don Day <fsufan1952@yahoo.com> wrote:
>
> Hello List
> I was sandplasting my BJ-8 gas tank and I found 2 small pin
>holes.Iactually put a pin in the hole and it fell all the way through! Its the
>part
> of the tank that is on the bottom between the tank and the lower shroud .My
> question is has any one had any luck good or bad with welding the holes up
> or do I need to get a new tank?I would have the body shop weld the holes up
> if I go that way.Any help?
> Don
> BJ-8 Phase II under re-construction
|