| To: | Rich C <richchrysler@quickclic.net> |
|---|---|
| Subject: | Re: Convertible Top Seals |
| From: | Alan Schultz <alan@andysnet.net> |
| Date: | Thu, 09 Nov 2006 12:29:45 -0600 |
Still wish someone would post a few photos of the installation!! Alan Schultz 67 BJ8 Rich C wrote: > No, the end cap fits over the entire seal/retainer assembly. The slit > is cut into the cap on the inside so the V portion in the cap can fit > into the barbed portion of the seal retainer. The length of the seal > should be matching the cantrail flange so that with the end caps in > place they just come together to neatly butt up against each other. |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Re: SV: Found wondering around the internet...., Richard Hosmer |
|---|---|
| Next by Date: | Re: SV: Found wondering around the internet...., David Crawford |
| Previous by Thread: | Re: Convertible Top Seals, Rich C |
| Next by Thread: | Replacing Rear Springs, Ned Smith |
| Indexes: | [Date] [Thread] [Top] [All Lists] |