healeys
[Top] [All Lists]

Re: fuel gauge sending unit lead

To: "Bob & Melanie Haskell" <rchaskell@earthlink.net>
Subject: Re: fuel gauge sending unit lead
From: "Craig and Sue Rice" <craigsuerice@iquest.net>
Date: Sat, 30 Dec 2006 17:25:57 -0500
 Bob,
 On an original wired BN2 the sending unit lead passes through it's own rear
 bulkhead grommet/hole located two inches to the right of fuel tank 5/16
 diameter outlet pipe at top of fuel tank elevation, under the "boot main
 floor covering assembly (4B 2208)" to the sending unit.
 Craig Rice
 BN1 & BN2
 ----- Original Message ----- 
 From: "Bob Haskell" <rchaskell@earthlink.net>
 To: "healeylist" <healeys@autox.team.net>
 Sent: Saturday, December 30, 2006 1:10 PM
 Subject: fuel gauge sending unit lead


 Listers,

 A question on the routing of the lead for the sending unit - does it go
 through the grommet/hole in the rear bulkhead for the rear harness or does
it go
 through the smaller hole just inboard of the first hole?  Then, what is its
path
 to the sending unit?  Run along the back of the tank or along side?

 Thanks,

 Bob




<Prev in Thread] Current Thread [Next in Thread>