finally got around to spinning the engine on the bn6. cranked it for a while
but no oil came out of the tube that feeds the oil pressure guage. the engine
has been sitting quite a while so the oil i put in the pump earlier might have
oozed out. i remember listers talking about priming the pump by squirting oil
from an oil can down into the gallery and into the pump. is this a good way
to do it or does someone have a surefire, easieer way of priming(if that is
necessary)>. healeymanjim
healeymanjim@joimail.com
EarthLink Revolves Around You.
|