Henry,
I place a block of 1"x2" pine along the shroud side flange just above the
door hinge brace structure. Then I can carefully pry against the wood which
is spreading the load along the flange and the shroud will start to loosen.
I pry a little on each side, going back and forth until the shroud comes
free. It's always worked well for me without causing any damage to anything.
Rich Chrysler
----- Original Message -----
From: "henry" <henry@vmtrc.ucdavis.edu>
To: <Healeys@autox.team.net>
Sent: Saturday, June 30, 2007 5:25 PM
Subject: [Healeys] Front Cowl
> Hello List:
> I am trying to remove the aluminum front cowl. (The last body panel)
> I have drilled all the rivets. I have removed the front bottom mounts.
> I have removed all screws from around the engine compartment.
>
> The cowl feels lose forward of the firewall, but is hard fast from the
> firewall back.
> I am trying to go slow and easy, but I can't find where its stuck.
> Any advise would be greatly appreciated.
>
> Thanks
> Henry
> 1955 BN1
_______________________________________________
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
|