| To: | Healeys <healeys@autox.team.net> |
|---|---|
| Subject: | [Healeys] Smitty Conversion- Throw out bearing and arm |
| From: | linwood rose <linwoodrose@mac.com> |
| Date: | Sat, 13 Oct 2007 17:09:51 -0400 |
I am now installing the Smitty conversion to Toyota gearbox to the engine. In the photo below please see points where I assume one would use a thin coat of high temp grease. 1. the shaft that the throw-out bearing rides on and 2. The pivot ball that the arm rotates against. Am I correct about this? Thanks. http://gallery.mac.com/linwoodrose#100049/ clutch-20grease-20points&bgcolor=black Lin 1960 BT7 in restoration 1959 Bugeye _______________________________________________ Healeys@autox.team.net http://autox.team.net/mailman/listinfo/healeys |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Re: [Healeys] Import Duty, PG |
|---|---|
| Next by Date: | Re: [Healeys] radiator hose leak while on a western adventure, NPaul72464 |
| Previous by Thread: | [Healeys] No Healey content Lock Tabs or Loctite?, Ron Fine |
| Next by Thread: | Re: [Healeys] Smitty Conversion- Throw out bearing and arm, John Sims |
| Indexes: | [Date] [Thread] [Top] [All Lists] |