Lin--
I could not view the photo but I believe that the Healey's ventral
lubrication system combined with the slipstream of air passing beneath the car
will
take care of this.
Hope I see you at Hunt Country tomorrow.
Best--Michael Oritt
-----------------------------------------------------------------------------
In a message dated 10/13/2007 5:11:05 P.M. Eastern Daylight Time,
linwoodrose@mac.com writes:
In the photo below please see points where I assume one would
use a thin coat of high temp grease. 1. the shaft that the throw-out
bearing rides on and 2. The pivot ball that the arm rotates against.
_______________________________________________
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
|