healeys
[Top] [All Lists]

Re: [Healeys] VIN plate

To: "WILLIAM B LAWRENCE" <ynotink@msn.com>, <sbyers@ec.rr.com>,
Subject: Re: [Healeys] VIN plate
From: "Rich C" <richchrysler@quickclic.net>
Date: Tue, 27 Nov 2007 20:22:17 -0500
I was working with a resin model manufacturer a couple of years ago but 
beyond casting a couple of masters from originals that had to then be 
blanked out and cleaned up before a production mould could be made, he 
didn't get any further. Ever try to push a rope up hill?
This appears to be a good method to get what we need, because this material 
would take a machinists stamp very well. He claimed he could even cast them 
in an ivory colour instead of the pure white resin.
When I ran a survey asking how may folks would be interested in these I only 
got responses from 18 people.

Rich Chrysler

----- Original Message ----- 
From: "WILLIAM B LAWRENCE" <ynotink@msn.com>
To: <sbyers@ec.rr.com>; <healeys@autox.team.net>
Sent: Tuesday, November 27, 2007 8:11 PM
Subject: Re: [Healeys] VIN plate


> Next question, how about the plastic plate that goes on the kick panel in
> the BN1?
>
> Bill Lawrence
> _______________________________________________
> Support Team.Net http://www.team.net/donate.html
>
> Healeys@autox.team.net
> http://autox.team.net/mailman/listinfo/healeys 
_______________________________________________
Support Team.Net http://www.team.net/donate.html

Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys

<Prev in Thread] Current Thread [Next in Thread>