Lin, I'm not sure about your answer but I do remember a suggestion to
leave the blower motor unattached so you can move it around a bit to get to
the area your speaking. Install the blower screws later.
Good Luck, Mark
----- Original Message -----
From: "linwood rose" <linwoodrose@mac.com>
To: "Healeys" <healeys@autox.team.net>
Sent: Thursday, December 20, 2007 9:26 PM
Subject: [Healeys] RH fender mounting
> Sometime in the last five years I recall reading a suggestion to deal
> with the
> difficulty of accessing that awkward third bolt on the right hand
> fender. As I
> recall, the person offered that if you place the fender nut on the
> shroud rather
> than the fender at that location, you can put that bolt in from the
> fender side
> rather than having to reach around the cooling hose on the engine side.
>
> I am going to be mounting my front shroud and fenders this weekend and
> wondered about the suggestion. Does the idea work?
>
> Wisdom from the list?
>
> Thanks.
>
> Lin
> 1960 BT7 in restoration
> 1959 Bugeye
> _______________________________________________
> Support Team.Net http://www.team.net/donate.html
>
> Healeys@autox.team.net
> http://autox.team.net/mailman/listinfo/healeys
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
|