Jim -
You are confused.
That screw (on Plate N5) is to hold the carpet snap studs to the
tunnel cover. The screw you are talking about is referenced on Plate
A4 #21 - PTZ 808 and PTZ 807.
The guide is correct.
Best,
Alan
On 9/21/08, Jim Lyons <jlyons4@rochester.rr.com> wrote:
> I have a 1966 BJ8. I want to make sure that I am using the correct
> original hardware to secured the transmission tunnel.
>
> The Originality Guide (page 167) states that the tunnel is secured with #8
> Posidrive pan head sheetmetal screws.
> However, my Body Service Parts List AKD 3524 ( plate N5 ) shows a screw
> and nut used to secure the tunnel. These are parts CMZ 0208 and CNZ 102.
>
> Has anyone secured the Transmission Tunnel with the screw and nut on phase
> II BJ8 ? I was wondering why this was not noted in the Originality Guide.
>
> Thanks,
>
> Jim
> _______________________________________________
> Support Team.Net http://www.team.net/donate.html
>
> Healeys@autox.team.net
> http://autox.team.net/mailman/listinfo/healeys
>
> You are subscribed as healey.nut@gmail.com
>
> http://www.team.net/archive
>
--
Sent from my mobile device
Alan
'52 A90
'53 BN1
'64 BJ8
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
http://www.team.net/archive
|