healeys
[Top] [All Lists]
<prev [Date] next>
[Advanced]
 <prev [Thread] next>

[Healeys] Hub bolt insert procedure - Late BN1 to BJ8

from [Alan Seigrist] [Permanent Link][Original]
To: Healey <Healeys@autox.team.net>
Subject: [Healeys] Hub bolt insert procedure - Late BN1 to BJ8
From: Alan Seigrist <healey.nut@gmail.com>
Date: Fri, 17 Apr 2009 22:48:51 +0200 
All -

I am trying to insert the special hub bolts in the 5 bolt hub on the
rear axle and I can't seem to do it without damaging the splines on
the shoulder of the bolt.

Is there a tried and tested procedure for getting these bolts in the
hub without damaging them?

Its probably been covered before but I really want to make sure I do it right.

Thanks,

Alan

-- 
Sent from my mobile device

Alan

'52 A90
'53 BN1
'64 BJ8
_______________________________________________
Support Team.Net http://www.team.net/donate.html

Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys


http://www.team.net/archive
[More with this subject...]
<Prev in Thread] Current Thread [Next in Thread>
Previous by Date:  Re: [Healeys] Motor mounts - RH/LH?, andy pole
Next by Date:  Re: [Healeys] Hub bolt insert procedure - Late BN1 to BJ8, andy pole
Previous by Thread:  [Healeys] Hardtop rally vent interior treatment, Tracy Drummond
Next by Thread:  Re: [Healeys] Hub bolt insert procedure - Late BN1 to BJ8, andy pole
Indexes:  [Date] [Thread] [Top] [All Lists]